JET 708404 Instrukcja Użytkowania i Eksploatacji

Operating Instructions and Parts Manual Benchtop Oscillating Spindle Sander Model JBOS-5 For models with serial no. 11095097 and higher JET 42

10Optional Accessories (purchased separately) 709534 ... 3” Dia. Spindle Assembly 6286984 ... Table Insert for 3” Spindle Sanding Sleeves (4 pe

11Table Assembly for the JBOS-5

12Base and Motor Assembly for the JBOS-5

13Parts List for the JBOS-5 Index No. Part No. Description Size Qty 1 ... 6286914W ... Base...

14Index No. Part No. Description Size Qty 62 ... 6286894 ... Main Spindle serial #2014090 & lower ...

15

16 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools.com

2Warranty and Service JET, Wilton and Powermatic warrants every product they sell against manufacturers’ defects. If one of our tools needs service o

3Table of Contents Warranty and Service ...

4 Warning 1. Read and understand the entire contents of this manual before attempting assembly or operation. Do not use this tool until proper train

5Introduction This manual is provided by JET covering the safe operation and maintenance procedures for a JET Model JBOS-5 Oscillating Spindle Sander

6Unpacking and Setup Contents of the Shipping Container (see Figure 1) 1 Spindle Sander 1 Spindle Storage Plate (pre-installed) 1 Insert Storage Pl

7Insert Plates 1. Always use an insert plate. 2. There are 2 oblong, and 2 round insert plates included with the machine. The oblong insert plates

8Turning the Sander On & Off Note: Before hooking the sander to the power source, make sure the switch is in off position. The sander can be turn

9Insert Plate Diameters This will assist you in determining which spindle diameters will work in each insert plate.