Operating Instructions and Parts Manual Drum Sander Model: 10-20 Plus WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne,
10Controls On/Off Switch Before powering up the unit, make sure all of the tools used to assemble and adjust the unit are removed and accounted for.
11Adjustments Drum Height Control Drum height is controlled by the height adjustment handle (A, Fig. 5). Turning the handwheel in a counterclockwise
12Drum Alignment The sanding drum comes preset from the factory. If a problem with the drum alignment occurs, follow the instructions listed below. C
13Wrapping Abrasive Strips Note: When using JET “Ready to Wrap” and “Ready to Cut” abrasives, not all of the steps below are necessary. You can use t
14Using the TUF ToolTM The Tuf Tool (Figure 13) can also be used to hold the take-up fastener in place while you feed the sandpaper through the slot.
15Connecting Sander to a Dust Collector Dust collection is necessary for all drum sanders. The JET 10-20 is equipped with a 4” dust collection port i
16Abrasives Overview The abrasive material you choose will have a substantial effect on the performance of your sander. Variations in paper type, wei
17Stock Feeding Angle The optimum stock feeding angle, when sanding, is at a 60-degree angle. However, even a slight stock feeding angle will provide
18Conveyor Belt Replacement To replace the conveyor belt: 1. Disconnect the machine from the power source. 2. Raise the drum to its highest positio
19Troubleshooting Problem Possible Cause Solution Conveyor belt does not move. Shaft coupler is not attached. Attach the shaft coupler. Conveyor r
2Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Aut
20Parts Parts List Index No Part No Description Size Qty 1 ... 1020-101 ...Handwheel, Height Adjustment ...
21Parts List Index No Part No Description Size Qty 55 ... 10-4010-08 ...Socket Head Cap Screw ...
22Assembly Drawing
23Optional Accessories JET 10-20 Sander Accessories Stock # Description 638004 Open Stand with Shelf for 10-20 Plus and 16-32 Plus Sanders 98-0130
24 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.jettools
3Table of Contents Warranty and Service ...
4 Warnings 1. Read and understand the entire owner's manual before attempting assembly or operation. 2. Read and understand the warnings poste
5 23. Check damaged parts. Before further use of the machine, a guard or other part that is damaged should be carefully checked to determine that it
6Introduction This manual is provided by JET covering the safe operation and maintenance procedures for a Model 10-20 Plus Drum Sander. This manual c
7Unpacking Separate all parts from the packing material. Check each part against the Contents of the Shipping Container and make certain that all ite
8Installing the TrackersTM Trackers dramatically reduce tracking adjustments of the conveyor belt by guiding the belt towards the center of the rolle
9Electrical Electrical Requirements When connecting the drum sander to the power source outlet, the outlet must be properly grounded to protect the o
Komentarze do niniejszej Instrukcji